Instructions for use of the Rack-it slide assist device

1: A. MAKE SURE BELT CLIP MODEL IS PROPERLY SECURED TO BELT AT DESIRED LOCATION.
    B. MAKE SURE WALL MOUNT BRACKET MODEL IS PROPERLY FASTENED AT DESIRED LOCATION USING BOTH SCREW HOLES.  (RECOMMENDED MOUNTING HEIGHT IS WAIST LINE AND/OR BELOW.)
 
2: PLACE FIREARM PROPERLY IN YOUR NATURAL OPERATING “STRONG” HAND POSITION.
            NOTE: MAKE SURE SAFETY LOCK IS DISENGAGED
 

3: WITH TRIGGER FINGER IN THE “NON THREAT” NEUTRAL POSITION, PLACE FIREARM IN THE RACK-IT SLIDE ASSIST DEVICE, END OF BARREL FACING DOWN AND FIREARM SIGHTS CLOSEST TO BELT/WALL 
 
4: KEEPING A FIRM HOLD ON FIREARM GRIP AND TRIGGER FINGER IN THE NEUTRAL POSITION, QUICKLY AND FIRMLY PUSH FIREARM IN A DOWNWARD MOTION UNTIL THE TRAVEL STOPS. AT THIS MOMENT, QUICKLY PULL THE FIREARM UP AND AWAY FROM THE RACK-IT SLIDE ASSIST DEVICE, MAKING SURE TRIGGER FINGER REMAINS IN SAME NEUTRAL POSITION.
 
5: FOR BEST RESULTS, PRACTICE THIS TECHNIQUE SEVERAL TIMES WITHOUT THE MAGAZINE IN THE FIREARM. (FIREARM UNLOADED)
 
6: THE RACK-IT SLIDE ASSIST DEVICE CAN ALSO BE USED FOR UTILITY/MAINTENANCE PURPOSES. AFTER APPLYING THE DOWNWARD PRESSURE, HOLD THE FIREARM AT THE END OF THE TRAVEL AND ENGAGE SLIDE LOCK LEVER. THIS WILL HOLD THE FIREARM IN AN “OPEN” POSITION. SIMPLY REMOVE THE FIREARM FROM THE RACK-IT SLIDE ASSIST DEVICE BY SLOWLY PULLING UP AND OUT.
 
NOTE: ALWAYS STRIVE TO UTILIZE PROPER FIREARM HANDLING/SAFETY TECHNIQUES AT ALL TIMES, WHETHER THE FIREARM IS LOADED OR UNLOADED.
 
FOR VISUAL INSTRUCTIONS, SEE BELOW:

DISCLAIMER:

FAILURE TO FOLLOW PROPER FIREARM HANDLING / SAFETY TECHNIQUES COULD RESULT IN SERIOUS INJURY. RACK-IT LLC SHALL NOT BE HELD NOR ACCEPT ANY LIABILITY REGARDING INJURIES SUSTAINED WHILE USING THIS PRODUCT.